InMoov 01 : Printing and Building the InMoov Robot

12 Jun 2013 · 1 min

Watch on YouTube

0:42

In this segment of the InMoov robot tutorial, the presenter reviews the 3D‑printed hand components (parts 1‑5) that have just been printed. He explains that a rotatable wrist will be used instead of the originally printed wrist part, so the printed wrist piece is set aside. He then points out that the parts labeled “Robot Wrist Small” actually consist of two pieces that serve as the palm where the fingers attach, clarifying a naming mismatch in the design files.

Chapters

So now that you've printed out your parts for the robot hand, or hand robot as it's written, I'm going to go over them with you. This is robo parts 5, 4, 3, 2, and 1. Now we're going to go for a rotatable wrist, so we will not be using this. I didn't know that at the time, so I did print it. So put that aside. And also we go down to a robot wrist Large and Robot Wrist Small. And Robot Wrist Small is actually 2 pieces. And although, and although they say Robot Wrist, these are actually the palm pieces. These are the palm— these are where your fingers will attach.