InMoov 12 : Printing and Building the InMoov Robot

12 Jun 2013 · 1 min

Watch on YouTube

0:38

This content was created by Thomas Messerschmidt. This content was uploaded by Thomas Messerschmidt. This is a YouTube video titled "InMoov 12 : Printing and Building the InMoov Robot" (posted June 12, 2013). The excerpt is a hands-on tutorial/demonstration by a single presenter (labeled SPEAKER A) describing assembly steps for the InMoov robot—specifically fitting and trimming a robot cable guide, gluing it in place, and positioning multiple servo motors (noting 3 in one location and 2 in another). The content is instructional and focused on building the 3D-printed InMoov robot.

Chapters

Now this is the simple servo bed, and this is the robot cable guide, and it just kind of pushes in like this. You probably will have to trim it down a bit. This is really hard to do one-handed. And it goes like this, and again, it gets glued in place. And then there's another guide for the second set. There's 2 sets, 3 servo motors. 3 go here, 1, 2, and 3, and 2 will go here. And then there's another guide For that second set, which I've misplaced.